AIGLE‘s machines are designed not only to flock rubber profiles. These machines are mainly used in the automotive industry as flocking gives profiles a soft, cleaning and aesthetic effect.
Discontinuous flocking for cut profiles is a process that over the last couple of years has shown great technical development. The purpose of this process is to flock one or more corners after the rubber profile assembly/molding. Several flocking techniques have been...
The Discontinuous Flocking Line for Cut Profiles – mod. LFPD is designed based on customer’s specific needs: Cycle description: – The profile that requires flocking is manually positioned on specific templates mounted on the conveyor...
The Pre-Vulcanization Unit – mod NIRV – 101 has 6 sections. Each section has two infrared lights where each lamp has an approx. length of 960 mm. The temperature of each zone can be adjusted separately via the PLC system. Max. surface temperature of NIR...
The Caterpillar mod. CTP800 consists of a strong, motorized frame installed in the lower part, and a couple of opposed 10 mm rubber covered “Poly V” belts, installed in the upper part. Drive transmission is obtained with a special “Schmidt” joint. A double...
The Cleaning and Cooling Unit mod. WCP6 is divided into three sections: – Water cooling and cleaning: a set of properly positioned nozzles uniformly sprays nebulized water on the profile, in this way the excess flock is removed and the profile temperature is...
The Hot Air Drying Oven mod. FAC12 is divided into four bays, each of three meters, and heats the profiles with hot air. Each bay is equipped with stainless steel finned pipe electric batteries, air distribution ducts and recirculating fans. The Hot Air Drying Oven...
The Suction & Pre-Cleaning Group mod. PRCP and mod. Jet-Matic is placed after the flocking machine to ensure a good pre-cleaning of the profile prior to its entrance in the oven and also to avoid excessive dispersion of flock during the various working...
The Electropneumatic Flocking Machine mod. FR/ESP is designed for the flocking of profiles with undercuts. It is a modular unit that is normally inserted next to the flocking machine with hopper and before the profile pre-cleaning system. It is used for high...
The Flocking Machine mod. FR1/R can be used independently or combined, either with one module or more, in order to obtain higher flocking speeds, or with a Flocking Machine mod. FR/ESP for flocking undercut profiles. The module includes: – Electrostatic...
The Adhesive Application Cabin mod. ADP6 is completely built in stainless steel and is equipped with anti-spark exhausters for adhesive fumes. The cabin is equipped to apply glue onto profiles using distributing brushes which can be easily replaced and oriented...
The Brushing Unit mod. SZ3 is used to clean profiles from sanding residue before glue application, or from flock residue after vulcanization. It consists of: – A structure on four wheels, allowing easy movability of the machine – Three brushes with natural...
The Sanding Machines mod. SUC3 and SUC2+1 are specifically manufactured to sand profile surfaces where adhesives will be deposited. This treatment is suggested for optimal adherence on EPDM profiles especially. It is for modular machines that are to be installed...
The Forced Air Cooling Unit mod. AFC is placed in a profile flocking line after the vulcanisation oven; its function is to lower the profile temperature before sanding and glue spraying. The unit is equipped with an A.C. motorized conveyor belt made with a Teflon...
